Author Topic: QuikSeps Pro ?  (Read 2686 times)

Offline 3Deep

  • !!!
  • Ludicrous Speed Member
  • *******
  • Posts: 5243
QuikSeps Pro ?
« on: October 13, 2016, 03:16:33 PM »
Got question for any of you that use QuikSeps Pro, is there a way to add a thicker white outline to the base white after the seps have been generated, I know I should have added it before the seps where done, might have to go back and redo it all.
Life is like Kool-Aid, gotta add sugar/hardwork to make it sweet!!


Offline UltraSeps

  • Full Member
  • ***
  • Posts: 104
Re: QuikSeps Pro ?
« Reply #1 on: October 13, 2016, 03:39:57 PM »
As long as your base has a defined border, select outside the base channel using the magic wand.  Then choose Inverse (not invert) so the edge of the base is selected.  Make sure the foreground color in the swatches on the tools panel is black.  Then go to Stroke, choose Center and enter a pixel value.  Click OK.  If not enough or too little, undo, go back and enter a different value.
« Last Edit: October 13, 2016, 03:43:54 PM by UltraSeps »
Developer of UltraSeps and QuikSeps Color Separation Software. 
Oh yeah, I actually printed t-shirts too for over 30 years.
www.ultraseps.com   www.quikseps.com   www.customseps.com