Author Topic: Integrator Acting Weird  (Read 588 times)

Offline mimosatexas

  • !!!
  • Gonzo Member
  • ******
  • Posts: 4221
  • contributor
Integrator Acting Weird
« on: June 29, 2018, 09:59:51 AM »
So I had to unplug my Olec AL53 from my integrator, and when I plug the controller cable into the integrator it automatically opens the shutter, turns on the light and just goes.  Clicking cancel or power on the integrator does not stop the Olec, it just stays open and exposing.  Only way to turn it off that I've figured out is to unplug the cable again.  Any ideas?

edit: couldn't get ahold of Douthitt before posting, but they just called me back.  Sounds like the photocell cable is bad (i was mistaken in the original post on which cable was causing the issue).  Changing to "seconds" mode vs using the timer and everything is working properly.
« Last Edit: June 29, 2018, 10:15:04 AM by mimosatexas »