Author Topic: Heat pressing discharge  (Read 1364 times)

Offline Pangea

  • !!!
  • Full Member
  • ***
  • Posts: 228
  • Jack of all trades, master of none.
Heat pressing discharge
« on: October 26, 2018, 04:39:49 PM »
I have a small unreliable dyer that I was using for water based/discharge but have recently gone back to heat pressing until I can upgrade to something more reliable. When I press discharge red ink if I don't do it in 10 seconds intervals the red fades to more of a pink in areas. Is there a reason that this happens that I can avoid or is this just something that happens when using a color with a lot of red pigment?


Offline blue moon

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 6355
Re: Heat pressing discharge
« Reply #1 on: October 28, 2018, 10:39:44 AM »
try reducing your ZFS to 3% when printing red ink.
pierre
Yes, we've won our share of awards, and yes, I've tested stuff and read the scientific papers, but ultimately take everything I say with more than just a grain of salt! So if you are looking for trouble, just do as I say or even better, do something I said years ago!

Offline RICK STEFANICK

  • Gonzo Member
  • ******
  • Posts: 1925
  • INDUSTRY CONSULTANT-OPERATIONS SPECIALIST
Re: Heat pressing discharge
« Reply #2 on: October 29, 2018, 03:05:46 PM »
try reducing your ZFS to 3% when printing red ink.
pierre
Pierre is correct 3-4.5 percent is recommend in reds and yellows depending on the mfg.  also dissolve you activator in warm water before pouring into the ink for better dispersion. Also if you can hover over the print without pressure that will help tremendously.
Specializing in shop assessment's, flow and efficiency

Offline Pangea

  • !!!
  • Full Member
  • ***
  • Posts: 228
  • Jack of all trades, master of none.
Re: Heat pressing discharge
« Reply #3 on: October 31, 2018, 10:29:07 AM »
try reducing your ZFS to 3% when printing red ink.
pierre
Pierre is correct 3-4.5 percent is recommend in reds and yellows depending on the mfg.  also dissolve you activator in warm water before pouring into the ink for better dispersion. Also if you can hover over the print without pressure that will help tremendously.

I've been activating red at 4% but direct to heat press with light pressure really blows out the color. I'll try out the hover method and see how it works out, thanks for the advice!

Offline RICK STEFANICK

  • Gonzo Member
  • ******
  • Posts: 1925
  • INDUSTRY CONSULTANT-OPERATIONS SPECIALIST
Re: Heat pressing discharge
« Reply #4 on: October 31, 2018, 10:55:48 AM »
Please post your result.
Specializing in shop assessment's, flow and efficiency