Author Topic: How would ya'll print this?  (Read 1221 times)

Offline tse1990

  • !!!
  • Verified/Junior
  • **
  • Posts: 51
How would ya'll print this?
« on: November 05, 2018, 11:26:17 AM »
50 shirts - Black Gildan 2000

Thanks in advance!


Online zanegun08

  • Hero Member
  • *****
  • Posts: 669
Re: How would ya'll print this?
« Reply #1 on: November 05, 2018, 11:45:08 AM »
Probably not the way most people do it.

But we would print a solid base of orange with it a little choked back on the right side.

And then come back with a halftone green that doesn't actually stop, but goes 3 percent dot (adjust to your lowest percent dot you can hold consistent) all the way to the left.

That way you can avoid the line you would get if you were to just stop the halftones.

You could do this with discharge, or a discharge base (80% base / 20% premix white) and plastisol on top so your hand isn't super thick.

Offline blue moon

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 6355
Re: How would ya'll print this?
« Reply #2 on: November 05, 2018, 01:42:16 PM »
I think you are just going the get stuck with a line where the colors transition out. The orange and green are just to clean to get away with a 5% dot under it. If your customer is OK with it though, that would be the answer.

pierre
Yes, we've won our share of awards, and yes, I've tested stuff and read the scientific papers, but ultimately take everything I say with more than just a grain of salt! So if you are looking for trouble, just do as I say or even better, do something I said years ago!

Offline RICK STEFANICK

  • Gonzo Member
  • ******
  • Posts: 1925
  • INDUSTRY CONSULTANT-OPERATIONS SPECIALIST
Re: How would ya'll print this?
« Reply #3 on: November 05, 2018, 02:07:44 PM »
Be sure you run the green and orange WOW then flash and run a highlite white

white base- 160
flash
orange- 230-280
green- 230-280
flash
highlite white
Specializing in shop assessment's, flow and efficiency