Author Topic: Proper Off Contact in Screen Printing  (Read 463 times)

Offline printavo

  • Sr. Member
  • ****
  • Posts: 270
Proper Off Contact in Screen Printing
« on: June 19, 2019, 10:58:27 PM »
"Did you check your off-contact?" It's the go-to answer for so many problems in screen printing! Matt Marcotte tells us: "This is a massive thing that is frequently overlooked. Once you control it, you can really make the prints do what you want to do."

If you don't have proper off contact, the screen will not get its proper peel. You'll see prints that look like a stucco ceiling or cement – small dots, pockmarks, protrusions, and generally undesirable texture.

So, what is off contact? It's a small gap between your screen and whatever garment you're printing on. Matt tells us that a nickel's worth (right around 2 millimeters) is a great start – but you'll need to adjust it according to the thickness of your garments. Hoodies will need more off contact than a t-shirt since they're thicker.

Why does off contact matter so much? Basically, when your off contact is off target, the screen sticks to the ink. With proper off contact, the screen "peels away" from the wet ink instantly, leaving no undesirable textures in the print.

NOTE: There ARE reasons for on contact printing (such as certain water-based inks and various substrates). But for simple plastisol screen prints, off contact is a must-have.

The magic trick here? Maintain constant screen tension. You really want your screens to be at the same tension for a job – don't run 22 N screens next to 18 N screens. This is where an affordable screen tension meter can really improve the quality of your prints and help you gain control over an important variable in screen printing.

Watch the video here: https://www.youtube.com/watch?v=6xVLXO_1RRQ
https://www.printavo.com - Printavo, simple shop management software.


Offline alldayscreens

  • Verified/Junior
  • **
  • Posts: 10
Re: Proper Off Contact in Screen Printing
« Reply #1 on: June 21, 2019, 12:38:41 PM »
Great video!  ;D But uh, what do you mean by "affordable" tension meter? I really only see them around $400 - and for those just starting out, it may not be high on the priority list.

Offline Steve Harpold

  • Full Member
  • ***
  • Posts: 111
Re: Proper Off Contact in Screen Printing
« Reply #2 on: June 21, 2019, 05:29:01 PM »
Hey,

Simply put, if your press is not set up as described (which is the case with most manuals, it hard to set them up or they are incapable of correct off contact) than tape a paint stick to the north and south part of your screen. Ensure the paint stick makes contact with the pallet as you lower the screen. At this stage you will have 1/8” off contact and your screen tension will not matter as long as it exists (yes, I know this is it proper technique but will help those who are worried about an expensive meter) side note 2.0 (the meter only tell you your static screens are below tension, the meter is the cheap part, as getting the new screens at a better tension is the expensive part.) Now you will have off-contact and proceed as described, the results will be better regardless of what the meter says. (As long as your tension problem is not obsurd)