TSB

screen printing => Equipment => Topic started by: RZRevo on May 16, 2018, 11:59:12 AM

Title: Challenger I wiring issue Early to mid 90's
Post by: RZRevo on May 16, 2018, 11:59:12 AM
If anyone has a early to mid 90's Challenger 1, I could really use your help. I just finished referbishing 10/12 all air model. The one I have has the shirt detector located between heads 1 and 10 mounted on the top center area where all the wires and tubes come up through the center, but any Challenger I wiring photos would be helpful. Anyways, I can't figure out how to the wiring for the no shirt detector, safety cord and heads 1 & 10 is connected. If anyone could send me some detailed pictures of wiring on your machine, It would be greatly appreciated. I tried to get the info from M&R, but after sending them several pics and numerous e-mails, they have been able to give me the right information. steve@rzrevo.com 402-630-7145
Title: Re: Challenger I wiring issue Early to mid 90's
Post by: californiadreamin on May 19, 2018, 10:15:55 PM
If your ch1 does not have keypad
T-shirt sensor is wire #132 going to terminal 12 on  cpu 0412 unit#4
Saftey cord is wire #12going to terminal 7A cpu10106 unit#0
Head 1 front prox wiire #22,rear prox wire #23
Head 10 front prox #76, rear prox#77
This is based on no modifications
Good luck
Winston
904.3430848