TSB
Embroidery => General Embroidery => Topic started by: evilcaps on August 02, 2011, 11:53:29 AM
-
Just Finish this Pre-sample.
Looks ok?
-
Those are some massive satin stitches, did you have to adjust machine parameters to not auto split them?
-
Those stitches must be longer than a 1/2" (12 mm). Which machine are you using and how fast you ran those hats?
Looks good BTW
-
Yep, Needed to change the machine settings.
-
very nice work..
-
I have a tajima tmfx speed not very fast, 600 in cap mode so 350-480spm. Very low speed.
-
Very good work. I like that look of that Gold in 3D and is done well.
-
your 3d work is amazing, id give anything to sew that tall :( 2.1" is KILLING ME.
-
Evilcap what kind of foam are you using or are you stacking your foam, I bought some 3mm foam hoping I could get a higher 3D look with it.. thinking I need to adjust my tension so the thread won't pull so tight. Your cap looks awesome.
-
yep 3mm foam form madeira,
-
Another 3D Job
-
Another one!
-
booth look very cool!
pierre
-
Nice job. What's your average speed for running those?
-
I set the machine to operate 650 on cap mode but it slows down up to 400-500 on the 4mm satin stitch, over 4mmm about 380 very slow!
-
here is another one
-
Where are you located? Have a website?
-
Vancouver, WA
Evilcpas.com
but still working on it
-
Nice work. The customer was very pleased.
-
:) Nice work, we are try some 3d ourselves, what type settings do you use? We are doing a end cap, light radial, end cap, then tight top stitch. But we are getting quite a bit of foam showing. If you don't mind sharing.
Thanks,
Shane
-
Double your density if you are having to much peeking out.
-
Portal 3d Job Pic.
-
Nice work. Glad things are working out.
-
auviq 3d
-
Portal 3d Job Pic.
Love me some Portal!