TSB

Computers and Software => Separation Programs => Topic started by: 3Deep on October 13, 2016, 03:16:33 PM

Title: QuikSeps Pro ?
Post by: 3Deep on October 13, 2016, 03:16:33 PM

Got question for any of you that use QuikSeps Pro, is there a way to add a thicker white outline to the base white after the seps have been generated, I know I should have added it before the seps where done, might have to go back and redo it all.

Title: Re: QuikSeps Pro ?
Post by: UltraSeps on October 13, 2016, 03:39:57 PM

As long as your base has a defined border, select outside the base channel using the magic wand.  Then choose Inverse (not invert) so the edge of the base is selected.  Make sure the foreground color in the swatches on the tools panel is black.  Then go to Stroke, choose Center and enter a pixel value.  Click OK.  If not enough or too little, undo, go back and enter a different value.