« previous next »
Pages: [1]   Go Down

Author Topic: Chemical toy samples  (Read 801 times)

Offline tonypep

  • Ludicrous Speed Member
  • *******
  • Posts: 5624
Chemical toy samples
« on: May 07, 2014, 01:54:39 PM »
From our friends at Nazdar/CCI. Aqua block blockout for well, you know. Dries extremely fast. No post exposure requirement. So far holding up very well. CCI VPR emulsion. Exposing with half the units as with WR14. No diazo.
Logged

Offline Colin

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1610
  • Ink and Chemical Product Manager
Re: Chemical toy samples
« Reply #1 on: May 07, 2014, 02:48:26 PM »
Run Size?
Mesh count?
Squeegee hardness and pressure?
ZFS percentage?
Number of colors?
Halftone/Fine line?

Logged
Been in the industry since 1996.  5+ years with QCM Inks.  Been a part of shops of all sizes and abilities both as a printer and as an Artist/separator.  I am now the Ink and Chemical Product Manager at Ryonet.

Offline ScreenPrinter123

  • Hero Member
  • *****
  • Posts: 863
Re: Chemical toy samples
« Reply #2 on: May 07, 2014, 08:53:50 PM »
Just had some aqua block dropped off today by our CCI rep.  Wish I would have seen this so I could have asked for a sample of the emulsion
Logged

Offline Underbase37

  • Hero Member
  • *****
  • Posts: 790
Re: Chemical toy samples
« Reply #3 on: May 07, 2014, 10:24:38 PM »
Aqua block on a few screens that have been on & off the press three times, 2k runs.....seems to be holding up :-X

It does get a bit soft when washing the screen with water, but not bad here.

Murphy37

Logged
Pages: [1]   Go Up
« previous next »