Computers and Software > RIPs

T-Rip and Epson 3000

(1/2) > >>

Squeegie:
Anybody run into an issue where the T-rip output display shows exactly what you want to print and the Epson 3000 only prints 8.5 inches of the width?
Any and all settings for output media have been checked, changed, and retried many many times without any luck.
It does not matter if I output from Draw, Illustrator, or Photoshop.

Picture attached...
I have tried uninstalling and reinstalling drivers in windows.  I tried deleting and reinstalling print queues in T-Rip.
All without success. 
Any help would be appreciated.

Bill

cbjamel:
Make sure the page you send is the size of art. under print settings.

Make sense?

Shane

Squeegie:
Page size in all programs...Draw, PS, Illy, set to 13x19...output size in t-rip set to 13x19...preview is correct, actual print is not.

cbjamel:

--- Quote from: Squeegie on November 03, 2017, 05:31:43 PM ---Page size in all programs...Draw, PS, Illy, set to 13x19...output size in t-rip set to 13x19...preview is correct, actual print is not.

--- End quote ---
so in draw/illy got print, select printer-rip, preferences, advanced, page size and set the pages size. if dont it will do 8 1/2 x 11.

Hope this helps.

Sent from my SAMSUNG-SM-G890A using Tapatalk

Squeegie:
As already stated...Page size in all programs...Draw, PS, Illy, set to 13x19 This is not just the workspace page size, it is the preferences/advanced/paper size...output size in t-rip queue set to 13x19...preview is correct, actual print is not.

Navigation

[0] Message Index

[#] Next page