Heat Seal - Heat Press - Whatever you want to call it! > General Heat Seal
DTF on non-woven totes
Sbrem:
Yes, the polypropylene type. Rumor has it that we can apply DTF to these, at around 275°. I spoke with one of the manufacturers this morning, and he thought I could, as they did. Test, test, test of course. I did have a bag this morning that I gave a quick press to at 310°, and it melted very nicely. So who here has done them, and what advice might you have. It's for a rush of course...
Steve
3Deep:
Use a shirt over the print to reduce some of the heat and lighten up your pressure a little
Sbrem:
I just had successful test at 270°, with a leftover transfer. I think we have a winner...
Steve
TheGhost:
280 worked fine for us
Rockers:
--- Quote from: Sbrem on May 20, 2022, 04:54:40 PM ---I just had successful test at 270°, with a leftover transfer. I think we have a winner...
Steve
--- End quote ---
May I ask why you cannot go below 270F?
Are you limited by the powder or what is causing those high temp. settings?
Navigation
[0] Message Index
[#] Next page
Go to full version