screen printing > General Screen Printing
smoothing orange peel print
balloonguy:
I have some prints that look a little orange peeled. It is poly ink on camo hoodies. It looked fine inside when printing last week. I took them outside to get a picture and in the sun the prints are a little textured... Is there a good way to smooth the print after the fact?
Thanks,
Matt
Frog:
heat press
cbjamel:
heatpress with teflon sheet give a shiny finish or brown paper gives flat finish for us.
Shane
balloonguy:
Do you have a suggestion on temp/time/pressure. I have a 1620 hotronix.
Thanks for the quick reply!
Frog:
--- Quote from: balloonguy on October 09, 2023, 04:55:04 PM ---Do you have a suggestion on temp/time/pressure. I have a 1620 hotronix.
Thanks for the quick reply!
--- End quote ---
300, 5 seconds, medium pressure should do the trick, however, that camo stuff has a bad repution for bleeding.
So, I'd see no harm in starting testing at a lower temp
Navigation
[0] Message Index
[#] Next page
Go to full version