screen printing > Newbie

Printing plastisol on polyester vests

(1/1)

OhNoPrinting:
Tried my luck with printing on polyester vests (high-visibility vests)
(had a bit of puff ink left in the screen and used that)



* I love screen printing again :-)

I flashed the print and the yellow mesh took it really well, but the reflective band didn´t like the heat of the flash at all and was quickly shrinking: *I guess that means, I can´t let them go through the conveyor dryer but have to heat press them?



To avoid the bleeding of the ink, I could maybe just do a quick pre-flash to warm up?



And because it was just a test, I tested a DTF - and well .. I like it a lot.



I guess I really need to calculate time vs print costs vs miss prints again.

-and now of to the wash test. (but: who washes hi-vis vests actually??)

mk162:
We offer only a 1 color print on those. We use a low cure ink or additive and try to keep the heat as low as possible.

Rockers:

--- Quote from: OhNoPrinting on February 12, 2024, 07:48:20 AM ---

I flashed the print and the yellow mesh took it really well, but the reflective band didn´t like the heat of the flash at all and was quickly shrinking: *I guess that means, I can´t let them go through the conveyor dryer but have to heat press them?



--- End quote ---
You probably could run them through a dryer as the heat is a lot lower than on the flash. if in doubt always run the garment in question through the dryer at a lower temperature and if Ok increase the temperature and repeat until you get close to the curing temperature of the garment or the garment starts to shrink.

inkman996:
Same here only one color print or transfer. We print thousands a year and never seem to have an issue with the reflective taping in the oven. Would definitely avoid using a flash on them.

1964GN:
What they said. I have about 1k of those on deck. One color black ink and as low as you can go on dryer temp and no flash.

Navigation

[0] Message Index

Go to full version