screen printing > General Screen Printing

Auto reg systems and training

<< < (2/3) > >>

mk162:
we use it on every job, because it's less work and less maths than finding the center with a t-square

tonypep:
Thanks for the replies. So for some of you, have you eliminated registration marks altogether? I believe thats how we went at JNJ Dan might remember for sure

bimmridder:
The only time we MAY use reggies is on true 4CP. Otherwise too much time wasted taping and removing tape for something we don't need. We do have an information box on each screen, but that's one, 3'' piece of tape

CBCB:
In theory it should make even a one-colour job faster to set up. We set the print location too so we can load shirts to the same spot on every job.

Hard to make the operator care about it sometimes, they seem content to twiddle the knobs and load more test shirts.

prozyan:
Tri loc every job.  Very rarely use registration marks, especially since I'm semi-retired now and am a one man show.  Registration marks were used more often when I had employees doing the setup, but even then they were more for a comfort factor than a requirement.

Navigation

[0] Message Index

[#] Next page

[*] Previous page