Heat Seal - Heat Press - Whatever you want to call it! > General Heat Seal

DTF on 100% poly

(1/2) > >>

3Deep:
I had a cat bring in a 100% poly rain jacket type vest wanting a DTF print on it anyone press 100% poly without any trouble, I don't have anything in the shop like that material to test on.

Matt82:
I've done lots of poly shirts with no problems,  the only thing that I can think of that might be an issue is if there is any type of water repellent coating on it.

whitewater:
I just did some thin poly jackets from pennant.


275 for 10 sec.

Frog:
When I get different items like that, I try a test print with a small piece of a transfer in an inconspicuous spot

mk162:
Just did some here.  I prefer the low-melt from Supa for this.  I get less press marks.  I have switched a lot of stuff over, especially when it's 4 colors, left chest. It's easier to do and frees up the press for faster jobs.

Navigation

[0] Message Index

[#] Next page