1
General Screen Printing / Re: Small "tag" prints on back. Position?
« Last post by Frog on Today at 01:00:27 PM »I went in-between you two guys' position and am two fingers below the seam, about 1.5"
1
General Screen Printing / Re: Small "tag" prints on back. Position?« Last post by Frog on Today at 01:00:27 PM »I went in-between you two guys' position and am two fingers below the seam, about 1.5"
2
General Screen Printing / Re: Small "tag" prints on back. Position?« Last post by Admiral on Today at 12:36:56 PM »We do 1" from the bottom of the collar.
3
General Heat Seal / Re: DTF on 100% poly« Last post by 3Deep on Today at 11:55:43 AM »Thanks all, I passed on the job, it was only one piece plus it was a puffy type vest, but the advice on lower heat time and faster melting powder is good info I will use in the future.
4
General Heat Seal / Re: DTF on 100% poly« Last post by Admiral on Today at 11:44:09 AM »Just did some here. I prefer the low-melt from Supa for this. I get less press marks. I have switched a lot of stuff over, especially when it's 4 colors, left chest. It's easier to do and frees up the press for faster jobs. Are they just using a different powder adhesive for those? We lower are settings for poly when it is necessary, and always lower the time to apply better. I find they hold up great but on some garments you just can't avoid the press marks (we stay away from textured poly for example). 5
General Heat Seal / Re: DTF on 100% poly« Last post by mk162 on Today at 08:37:34 AM »Just did some here. I prefer the low-melt from Supa for this. I get less press marks. I have switched a lot of stuff over, especially when it's 4 colors, left chest. It's easier to do and frees up the press for faster jobs.
6
Private listings / Screen printing equipment« Last post by scott316 on Yesterday at 12:37:38 PM »Selling some equipment
Vastex v2000 4/4 M&r Kruzer 6/4 Little Red dryer 30 inch belt Workhorse power house 2608 Vastex 18x18 flash Antec legend 6/6 Text for picture and video 4045834903 7
General Heat Seal / Re: DTF on 100% poly« Last post by Frog on April 30, 2024, 01:38:22 PM »When I get different items like that, I try a test print with a small piece of a transfer in an inconspicuous spot
8
General Heat Seal / Re: DTF on 100% poly« Last post by whitewater on April 30, 2024, 11:43:34 AM »I just did some thin poly jackets from pennant.
275 for 10 sec. 9
General Heat Seal / Re: DTF on 100% poly« Last post by Matt82 on April 30, 2024, 11:38:25 AM »I've done lots of poly shirts with no problems, the only thing that I can think of that might be an issue is if there is any type of water repellent coating on it.
10
General Heat Seal / DTF on 100% poly« Last post by 3Deep on April 30, 2024, 11:04:52 AM »I had a cat bring in a 100% poly rain jacket type vest wanting a DTF print on it anyone press 100% poly without any trouble, I don't have anything in the shop like that material to test on.
|