TSB
Computers and Software => RIPs => Topic started by: 3Deep on October 07, 2016, 06:05:49 PM
-
Is it possible to run two different rip programs on the the same computer, I have accurip which runs my 1430 just fine but I would like to run the my 3000, but accurip don't show it on it's list of printers. I thought about loading and older rip that did run the old 3000.
-
I don't see why not, but I have no experience with it.
-
Just tossing this out there.
I think it depends on the RIPS. I believe Accurip is treated like a printer and output goes directly to Accurip where Accurip manages the printer. GhostRip, however, uses the postscript file created from the graphics application, like Corel.
Then again, I could be all wrong.
-
I`m a "collector" and run Wasatch SoftRip, AccuRip and FilmMaker from my laptop. I like having a choice.