Recent Posts

Pages: [1] 2 3 ... 10
1
General Heat Seal / Re: DTF on 100% poly
« Last post by whitewater on Today at 11:43:34 AM »
I just did some thin poly jackets from pennant.


275 for 10 sec.
2
General Heat Seal / Re: DTF on 100% poly
« Last post by Matt82 on Today at 11:38:25 AM »
I've done lots of poly shirts with no problems,  the only thing that I can think of that might be an issue is if there is any type of water repellent coating on it.
3
General Heat Seal / DTF on 100% poly
« Last post by 3Deep on Today at 11:04:52 AM »
I had a cat bring in a 100% poly rain jacket type vest wanting a DTF print on it anyone press 100% poly without any trouble, I don't have anything in the shop like that material to test on.
4
General Screen Printing / Re: Small "tag" prints on back. Position?
« Last post by rusty on Yesterday at 07:37:59 PM »
I usually do 2 inches from below collar to top of graphic, or three fingers.

5
General Screen Printing / Small "tag" prints on back. Position?
« Last post by Frog on Yesterday at 06:23:41 PM »
Where do you place the small pocket or sleeve sized prints we sometimes print on the backs of T's?
Let's use a business card size, 3.5" wide 2" tall as an example. I'm favoring 2" to the design top from the collar opening, (or 1.5" from the seam)
You guys similar?
6
General Art Discussions / Re: Proper PDF Saving out of Illustrator
« Last post by TheGhost on April 28, 2024, 04:22:26 PM »
I'd never considered that. I think I do drag sometimes as it is easier. Will try that method as well.
7
General Art Discussions / Re: Proper PDF Saving out of Illustrator
« Last post by Rockers on April 27, 2024, 05:59:57 PM »
Quote from: TheGhost on April 25, 2024, 07:44:46 PM
Can someone share with me the best settings for saving pdf mocks in Illustrator? We run into some issues recently where art doesnt show on pdfs sometimes and I cannot figure it out even if I rasterize. Is it a CC issue or is it a settings issue?
It depends as well on how you open the file.
We had the same issue on at least one of our MACs. If we dragged the actual file to Illustrator in the dock we had the same problems as you are experiencing. Right-clicking and then choosing "open with" solved it for us.
8
General Art Discussions / Re: Proper PDF Saving out of Illustrator
« Last post by TheGhost on April 27, 2024, 09:27:19 AM »
I think it may be embedding. Will give it a check on Monday!
9
Ink and Chemicals / Re: Yoga Mats?
« Last post by whitewater on April 27, 2024, 09:10:23 AM »
Thanks Dude!
10
Ink and Chemicals / Re: Yoga Mats?
« Last post by Admiral on April 26, 2024, 03:24:16 PM »
I found this quickly:

"Just called Nazdar and talked to Dan Miller. He said the DA series with DA 176 catalyst is the best for EVA foam. It takes about 24 hours to cross link and should be printed through a 110"

Source:Reddit

Sounds like what you were about to do.
Pages: [1] 2 3 ... 10