TSB

screen printing => Equipment => Topic started by: larryk on April 28, 2014, 03:12:48 PM

Title: Digital Display
Post by: larryk on April 28, 2014, 03:12:48 PM

I have an old HIX belt dryer that I would like to change the old style knob control for the heat to a digital display to set the temp. Anybody ever done this and if so could you share the process. Thanks

Title: Re: Digital Display
Post by: TCT on April 28, 2014, 05:29:25 PM

I did it for our speed control. Is pretty easy. Do you happen to have the wiring diagram for it?

Title: Re: Digital Display
Post by: larryk on April 28, 2014, 07:18:46 PM

I have the schematic for it that is on the cover.

Title: Re: Digital Display
Post by: jvanick on April 28, 2014, 07:26:00 PM

I did it... switched from an old athena temperature controller to an omron one... not too bad as long as you get the equivalent type controller (relay vs voltage outputs, and the correct voltage input)...


however, you'll have to figure out the settings for the new PID based ones... the factory defaults will probably not be correct for the interval time, deravitave, and process times.  that was my biggest/hardest hurdle.

after they were set better, it worked really nicely.

for the belt speed control, just hook up a digital volt meter to the output of your controller... the more volts going to the motor, the faster the belt.