TSB

Computers and Software => Raster and Vector Manipulation Programs, and How to Do Stuff in Them. => Topic started by: sportsshoppe on April 27, 2015, 07:13:44 AM

Title: CD X6
Post by: sportsshoppe on April 27, 2015, 07:13:44 AM

How do you set the default font in Corel X6? Thanks

Title: Re: CD X6
Post by: Sparkie on April 27, 2015, 08:09:16 AM

Here's a guide to changing CD X6 defaults.
http://www.engrave.ca/archives/5318 (http://www.engrave.ca/archives/5318)

Title: Re: CD X6
Post by: Frog on April 27, 2015, 08:31:24 AM

The short and sweet answer is whatever font you have set when you go to Tools/Save Settings as Default

Here, I chose Bauhaus just to illustrate the process.

Title: Re: CD X6
Post by: sportsshoppe on April 27, 2015, 06:07:36 PM

Duhhhhh I knew to save the default setting for pages but did not even think about using it for fonts. Thanks

Title: Re: CD X6
Post by: sportsshoppe on April 27, 2015, 07:18:59 PM

Well I could not get it to save as default and the guide had nothing on default fonts..... Anything else????

Title: Re: CD X6
Post by: Frog on April 27, 2015, 07:41:34 PM

so you're saying that if you type something in comic sans, and then do the Tools/Save settings as default, then close out, it does not default to Comic Sans when you open a new drawing? (Opening an existing drawing doesn't do it)

Title: Re: CD X6
Post by: Sparkie on April 27, 2015, 09:40:57 PM

Quote from: sportsshoppe on April 27, 2015, 07:18:59 PM

Well I could not get it to save as default and the guide had nothing on default fonts..... Anything else????

Using the guide I posted earlier:

Go down near the bottom and look for Expand the Artistic Text then go to the last section Make Your Change Default