TSB
screen printing => Equipment => Topic started by: Logoman on May 08, 2015, 07:12:51 PM
-
We were running a job today and the table turned suddenly and it broke the fork or clevis whatever it is called. I had an old one so I replaced it. Now it runs so bad I can't print on it. I tried to adjust with the M&R tech but could not get it right. Here is how it runs now. Anyone close to Little Rock, AR that can adjust this please contact me.
-
Fork needs to be floated at the very least, I would suggest start from scratch checking indexer stroke, checking bearings, dial in reg, etc. I would be more concerned why the fork broke in the first place.