TSB

Heat Seal - Heat Press - Whatever you want to call it! => General Heat Seal => Topic started by: AYDELOTT on August 15, 2015, 10:25:36 PM

Title: OL on my pressure reading
Post by: AYDELOTT on August 15, 2015, 10:25:36 PM

I just got a Stahls hotronix fusion it's my first press and the pressure setting blinks a number as I'm pulling the handle down but then says OLPR all the time it's not in the manual please help thanks

Title: Re: OL on my pressure reading
Post by: Frog on August 15, 2015, 11:13:48 PM

If no one here checks in with you before Monday morning, I'm sure that you'll get what you need from the folks at Stahls themselves

 800 . 727 . 8520 for tech support

Title: Re: OL on my pressure reading
Post by: chubsetc on August 16, 2015, 04:52:51 AM

Just a stab at it but is it possible your pressure is set way too high that's it's off the scale?  Try backing off the pressure and see if it lands into a readable pressure setting. Thinking OL could stand for over limit?

Title: Re: OL on my pressure reading
Post by: AYDELOTT on August 16, 2015, 09:27:32 AM

That's what I thought at first but with barely any pressure it does in thank you

Title: Re: OL on my pressure reading
Post by: Frog on August 16, 2015, 10:02:56 AM

I found this on YouTube where someone says they have a problem and eventually shows this reading, but, I don't really understand exactly what they are showing us.
https://www.youtube.com/watch?v=wmAemmM-IEE (https://www.youtube.com/watch?v=wmAemmM-IEE)

Title: Re: OL on my pressure reading
Post by: Binkspot on August 17, 2015, 10:58:34 AM

Call Stalls, their service department will walk you through resetting it. Ours was reading 9 with really light pressure, like what would be a 2. There is a sequence of buttons to push the reset it but can not remember how now.