TSB
screen printing => Equipment => Topic started by: Ross_S on August 04, 2016, 12:41:57 PM
-
Not sure how soon this would be available as I will need to remove them from all my frames. Anyways, I'm using Tri-Loc now and have no need for these. Not sure if anyone has any interest but again these are expensive as hell so it would be a good deal to someone.
-
if they are MZX, DIBS!!
I know sqslabs will take em.
-
M3's. I need to figure out how to get them off the screens and still keep production going. I probably have a couple hundred pairs.
-
M3's. I need to figure out how to get them off the screens and still keep production going. I probably have a couple hundred pairs.
use a battery powered impact wrench and just zip em out one by one as they come back to reclaim. You won't lose tension as long as you do one bolt at a time.
You'll need to replace the pin lock with the thick washer that used to be there. If you don't have those washers, you'll need to get some.
-
forgot all about the washers; damn it.