TSB
screen printing => Equipment => Topic started by: Val on November 17, 2016, 01:04:30 PM
-
Hi all. We've got an MHM e-type. Screen kept shutting down but always came back on with a reboot. Now won't come on at all. Hirsch Service is trying but cant' seem to figure it out. Suggested we purchased new mother board. Did that but it didn't help. $900. Testing everything along the way to be sure it's getting power, A-OK. They're stumped. Machine has been down over a week and no end in sight. Just ordered a new Flash Drive to see if that helps. Hirsch also suggested replacing the PCB connection but they don't have any to send us. Backordered several weeks.
We hooked up a regular monitor and it's just all code, so the control is not booting properly.
Anyone had this happen?
-
Check the power brick. Open the panel and locate the power supply. Try to power up the unit. If the led light flickers then the power supply is bad. Around $20 for the part.
-
Power brick would be my first choice. Try putting a meter on the power supply and see what it reads. Depending on the model, it should read 12 or 24 volts.
Properly working board has a fully functioning monitor port, if that is outputting gibberish, it can only be the power, the program or the board (from what I remember).
Pierre