TSB
screen printing => Screen Making => Topic started by: Rockers on November 30, 2016, 02:08:47 AM
-
Looks like we got a bad batch of carrier sheets for our tri loc.
The holes are not in the right position, especially not the one in the center. When we place them over the pins the sheet is not flat on the glass but rather forms some sort of a wave. Plenty of sheets are like this which makes it rather hard to line films up.
Had anyone here ever had a similar problem?
And yes I know the best solution to avoid this is to go CTS :)
-
Looks like we got a bad batch of carrier sheets for our tri loc.
The holes are not in the right position, especially not the one in the center. When we place them over the pins the sheet is not flat on the glass but rather forms some sort of a wave. Plenty of sheets are like this which makes it rather hard to line films up.
Had anyone here ever had a similar problem?
And yes I know the best solution to avoid this is to go CTS :)
Were those purchased from M&R? If so send me the invoice number and I will send you replacements out today.
-
Looks like we got a bad batch of carrier sheets for our tri loc.
The holes are not in the right position, especially not the one in the center. When we place them over the pins the sheet is not flat on the glass but rather forms some sort of a wave. Plenty of sheets are like this which makes it rather hard to line films up.
Had anyone here ever had a similar problem?
And yes I know the best solution to avoid this is to go CTS :)
Were those purchased from M&R? If so send me the invoice number and I will send you replacements out today.
Just wanted to follow up on this. Has this been taken care of? All I know is that the HK office is still waiting for a quote on freight charges from the US, which seems to take longer then expected:(
-
Looks like we got a bad batch of carrier sheets for our tri loc.
The holes are not in the right position, especially not the one in the center. When we place them over the pins the sheet is not flat on the glass but rather forms some sort of a wave. Plenty of sheets are like this which makes it rather hard to line films up.
Had anyone here ever had a similar problem?
And yes I know the best solution to avoid this is to go CTS :)
Were those purchased from M&R? If so send me the invoice number and I will send you replacements out today.
Just wanted to follow up on this. Has this been taken care of? All I know is that the HK office is still waiting for a quote on freight charges from the US, which seems to take longer then expected:(
should of been. I will check Monday and get back to you directly.