TSB
screen printing => Equipment => Topic started by: TCT on December 07, 2016, 06:10:50 PM
-
I know some people v have asked in other posts about maintenance on a Roq. Well this week on Monday the little maintenance icon came up on our YOU. I had planned on putting it off until Friday, but then today the maintenance icon came up on our ECO.
I decided to not put it off till Friday and did it today when everyone was on lunch. I had the presence of mind to time it for this post.
SO-
From beginning to end it took 34min.
YOU 8/10, 50k impression maintenance - 9min.
ECO 10/12, 150k impression maintenance - 19min.
I was not in a hurry to do it, leisurely pace. As long as you know how to use a alan wrench these are very realistic times.
-
Mine popped up Monday. I'm planning on doing it Friday.
-
Mine popped up Monday. I'm planning on doing it Friday.
You should report back(unless it takes you a few hours ;) ) on your time, if be interested!
-
Will do!
Of course if this took you 9 minutes, it will probably take me an hour ;D
-
Will do!
Of course if this took you 9 minutes, it will probably take me an hour ;D
If it is the 50K one, it is 5 3mm alan screws, about a dozen liberal sprays of lube and 2 min of letting the machine index.
-
"if you know how to use an allen wrench..." Damn, there's always a catch... :o
Steve
-
And you know if Alex says 19 minutes it's really only about three. At least that's what she said.
-
And you know if Alex says 19 minutes it's really only about three. At least that's what she said.
I save the other 16 for cuddling, like a gentleman...