TSB
screen printing => Equipment => Topic started by: Doug S on August 12, 2018, 11:34:21 AM
-
I'm thinking of buying a used tri-light 6000 watt exposure unit at a steal. This one isn't made for CTS but I was wondering if there would be a way to remove the glass and trick the unit into thinking that it was vacuuming so that I could use it to expose. I've done this with 2 exposure units I have but I was reading the brochure on it and it said the vacuum isn't attached to the blanket which would make it easy to do but would there be a way to plug the vacuum hose somewhere else?
-
Why would you even want to run the vacuum pump?
If it can be "fooled" it should be able to be re-wired to eliminate the entire vacuum circuit.
-
For me, that would require someone that knows about rewiring unless someone can give me step by step. All I know about electricity is there is a hot and a ground but that's about the extent of it.
-
You can set the vacuum to 0 and the machine will just bypass that step. You can fit 4 23 x 31 on the machine at a time without the glass. You will just have to fabricate a frame to hold your screens.
-
You can set the vacuum to 0 and the machine will just bypass that step. You can fit 4 23 x 31 on the machine at a time without the glass. You will just have to fabricate a frame to hold your screens.
Awesome Thanks! I’m looking forward to going from 1200 watt to 6000.
-
We went from 1,000 to 7,500 and LOVE it. Its a huge improvement.
-
You can set the vacuum to 0 and the machine will just bypass that step. You can fit 4 23 x 31 on the machine at a time without the glass. You will just have to fabricate a frame to hold your screens.
This ^
I have have seen many shops do this and they LOVE it. Keeps room cool b/c they have a longer time between exposures waiting for 4 screens (similar mesh obviously).
-
I just purchased it from a real standup guy. Now for the electrician and making room. Thanks for the advice.