TSB

Heat Seal - Heat Press - Whatever you want to call it! => General Heat Seal => Topic started by: Frog on July 09, 2021, 01:29:38 PM

Title: Graphtec CE6000 -Minimum length of extra vinyl needed when cutting sheets.
Post by: Frog on July 09, 2021, 01:29:38 PM

I know that there is a rear sensor to detect the trailing edge of sheets, but how close can one cut to that edge?

Title: Re: Graphtec CE6000 -Minimum length of extra vinyl needed when cutting sheets.
Post by: inkman996 on July 09, 2021, 01:32:11 PM

Quote from: Frog on July 09, 2021, 01:29:38 PM

I know that there is a rear sensor to detect the trailing edge of sheets, but how close can one cut to that edge?

On my machine as long as I laid out the images to fit the length of the piece I am cutting then when it gets to the limits on the sensor I just hit enter and it over rides the sensor and finishes the cut. Theoretically you can cut right up till the material is at its end under the rollers.

Title: Re: Graphtec CE6000 -Minimum length of extra vinyl needed when cutting sheets.
Post by: Frog on July 09, 2021, 01:57:47 PM

Quote from: inkman996 on July 09, 2021, 01:32:11 PM

Quote from: Frog on July 09, 2021, 01:29:38 PM

I know that there is a rear sensor to detect the trailing edge of sheets, but how close can one cut to that edge?

On my machine as long as I laid out the images to fit the length of the piece I am cutting then when it gets to the limits on the sensor I just hit enter and it over rides the sensor and finishes the cut. Theoretically you can cut right up till the material is at its end under the rollers.

That's good news, thanks