TSB

screen printing => Equipment => Topic started by: Croft on March 10, 2022, 07:02:49 PM

Title: M&R red chili d info
Post by: Croft on March 10, 2022, 07:02:49 PM

So my new press just finished up install today , the tech had only basic knowledge of the flash unit.
 We’re going to do some testing and hopefully a job tomorrow.
Can anyone give me a good starting point for plastisol ink , use the sensor to activate it or the control panel ? Starting approx temp and time?
Any info would help thanks

Title: Re: M&R red chili d info
Post by: Admiral on March 11, 2022, 01:30:02 PM

Use press control panel.

80% intensity 245F cutoff is what I would start with trying out.  Warm up platens before starting the print run.  Good luck!