TSB

screen printing => Waterbase and Discharge => Topic started by: jasonl on January 29, 2012, 08:40:35 AM

Title: How do you register your discharge jobs?
Post by: jasonl on January 29, 2012, 08:40:35 AM: Since its WOW, you cant really see whats going on until its through the dryer. I use the Tri-loc, but its not always perfect. I don't like to leave my waterbase in the screens to long for obvious reasons. Just wondering how everyone else approaches this? Also, I am using CCI discharge white, is anyone else using a single stroke with no top white, or do you find it necessary for a highlight white? Thanks in advance for your advice.
Title: Re: How do you register your discharge jobs?
Post by: tpitman on January 29, 2012, 10:09:20 AM: Set the job up with plastisol, then wipe the screens clean and load the discharge.
Title: Re: How do you register your discharge jobs?
Post by: jasonl on January 29, 2012, 10:32:08 AM: I was afraid someone was gonna say that!
Title: Re: How do you register your discharge jobs?
Post by: JBLUE on January 29, 2012, 12:12:48 PM: If I am doing darks I just print the colors on a white T.
Title: Re: How do you register your discharge jobs?
Post by: jsheridan on January 29, 2012, 12:31:09 PM: Quote from: tpitman on January 29, 2012, 10:09:20 AM
Set the job up with plastisol, then wipe the screens clean and load the discharge.

ahh... NO! talk about a freaking mess and waste of time.

use a white shirt
Title: Re: How do you register your discharge jobs?
Post by: jasonl on January 29, 2012, 01:25:59 PM: a white tee is what i do, what about a second white, is it necessary?
Title: Re: How do you register your discharge jobs?
Post by: RICK STEFANICK on January 30, 2012, 08:12:38 PM: you shouldnt need a highlight white. depending on the design you may can run the white last. it does build up a little more than some colors anyway..