TSB
screen printing => General Screen Printing => Topic started by: Denis Kolar on October 19, 2012, 12:38:46 PM
-
Do I need to have poly ink to print them or a regular Black plastisol will suffice?
Thanks
-
For black ink, you don't have to worry about poly dye migration, so use your regular ink.
-
Regular is fine. Some melt BADLY though so a low temp additive (IC) might be in order.
-
Regular is fine. Some melt BADLY though so a low temp additive (IC) might be in order.
That was my biggest concern :( I knew that there will be no dye migration to the black ink.
Thanks guys
-
The 3M brand reflective stripes like to pucker real bad so you either have to cover them with a template
(only reasonable on small runs) or use a low temp additive.
-
50 pieces
-
Never had one melt or striping pucker....i run them through a little faster as they heat up quick.....regular black ink.......but they stink!....fair warning......they give me a headache....the smell that is.
-
This is a good candidate for sublimation, if it's available.
-
I might try smaller pallets and flash curing. Smaller pallets so the excess of the vest will be hanging off the side.
-
Never had one melt or striping pucker....i run them through a little faster as they heat up quick.....regular black ink.......but they stink!....fair warning......they give me a headache....the smell that is.
this.
-
Finally printed these suckers.
Listened to Pierre and they came out pretty good looking.
-
nice, got a few boxes of these to do this week as well.