TSB
screen printing => Equipment => Topic started by: balloonguy on February 11, 2013, 04:02:28 PM
-
I bought one used a while ago. The timer never worked correctly. I replaced the timer with a brand new one. That is doing the same thing. I am guessing that there is some wire in the wrong spot somewhere. If anyone has the diagram I would greatly appreciate a copy.
Thanks.
Matt
-
I have an atlas 5 way shoot me a pic and I will compare as I have no manual me self.
Darryl
-
Thank you. I will send the pic tomorrow.
-
I sent a pm. I am not sure if the pic was attached so I am posting here too.
Thanks for the help. It is greatly appreciated.
(http://i489.photobucket.com/albums/rr252/balloonprinting/photo_zpsc9a8204b.jpg)
Matt
-
Here is what mine looks like from the bottom pretty much like what you got, but there's a jumper on one side as you can see in the pic hope this helps ya out.
Darrryl
-
I hate to be a pain but can you get a picture of where the hot wires go after the timer? I sent the new timer back to the factory and they load tested it. They say it is fine. I think my problem may be further down the line.
Thanks again.
-
Matt, your jumper wire is in a different location then Daryl's. Your relay is sending pwr from term 8 to 6 (top wire on right side) which should be a normally closed circuit. Daryl's is wired from 1 to 3 (top wire on left). In other words Daryl's pwr path is to the wire on term 3 and yours is the wire on 6, could be you are powering the wrong wire. It might be as simple as moving the hot leg from 8 over to term 2 and placing a jumper between 2 and 1. From what I can see the timer is powering the relay on the top, other wires going to the switches which also g to the relay on top. The powered wire on Daryl's is going to the switch not the relay from what I can tell from the pictures.
-
Matt, here are a few more pics, but I think blink might be right from what I see there also
Darryl