TSB

screen printing => Equipment => Topic started by: ericheartsu on June 04, 2013, 03:19:53 PM

Title: gauntlet filter/oiler
Post by: ericheartsu on June 04, 2013, 03:19:53 PM

would anyone happen to know the Grainger part number for a filter/oiler combo for an older gauntlet?

Title: Re: gauntlet filter/oiler
Post by: mk162 on June 04, 2013, 03:32:16 PM

there isn't 1 oiler that will work, there are a bunch, just match the inlet and outlet side and go from there.  Also, make sure it handles the CFM and pressure

Alos, mcmaster carr is cheaper.

Title: Re: gauntlet filter/oiler
Post by: ZooCity on June 04, 2013, 03:36:45 PM

Check out zoro tools if buying online.  I got a 3/4" Wilkerson FR (for right out of the comp, not the FLR on the press) on there for way cheaper than locally or grainger/mmc, and I bet they got FLRs on there too. 

Our '92 has an older Norgren setup that's still chugging along and I just got some new o rings for it. 

*sorry the above might have been confusing, you want 1/2" at the press for the FLR

Title: Re: gauntlet filter/oiler
Post by: Gilligan on June 04, 2013, 05:57:32 PM

Quote from: ZooCity on June 04, 2013, 03:36:45 PM

Check out zoro tools if buying online.  I got a 3/4" Wilkerson FR (for right out of the comp, not the FLR on the press) on there for way cheaper than locally or grainger/mmc, and I bet they got FLRs on there too. 

Our '92 has an older Norgren setup that's still chugging along and I just got some new o rings for it. 

*sorry the above might have been confusing, you want 1/2" at the press for the FLR

BOOM!  Wilkerson is highly recommended in other industries as well.

And Zoro is fairly cheap.