« previous next »
Pages: [1]   Go Down

Author Topic: My registration board  (Read 2079 times)

Offline steve1coelho

  • Verified/Junior
  • **
  • Posts: 14
My registration board
« on: February 19, 2015, 09:39:42 AM »
This is my registration board. I put 4 corners on here so when you set the screen in there is no movement.
Logged

Offline T Shirt Farmer

  • Hero Member
  • *****
  • Posts: 833
Re: My registration board
« Reply #1 on: February 19, 2015, 03:19:46 PM »
Nice DIY.. is it working as you expected... I think you may be slightly better off with a 3 point system vs 4 point if all corners of your creen frame are not square it may through the reg of tick from screen to screen.
Logged
Robert
allpremiums.com
Your Source for Decorated Apparel.

Offline Binkspot

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1108
Re: My registration board
« Reply #2 on: February 19, 2015, 05:37:43 PM »
This is what I use, second generation, third is in the works. Works fine just want it to look better. Yes it is Bri-Loc compatible.
Logged

Offline steve1coelho

  • Verified/Junior
  • **
  • Posts: 14
Re: My registration board
« Reply #3 on: February 19, 2015, 08:09:39 PM »
I have not used it yet still trying to get set up. I was looking to see what the thoughts were on this im sure someone has tried this before. I figured since I would be using newman exclusively that I would always have a square level screen. The three point do you use that on press as well?
Logged
Pages: [1]   Go Up
« previous next »